|SIMPSON STRONG-TIE NAIL 8D X 1-1/2" (0.131) HDG/ BULK SOLD PER POUND
This nail is sold per pound (FOR ORDERING IN BULK)
The approx. amount of nails per pound are 152.
Enter the quantity of pounds you require for this BULK PRICED NAIL
Products are hot-dip galvanized after fabrication (14 ga. and thicker). The coating weight increases with material thickness. The minimum specified coating weight is 2.0 oz./ft2 (per ASTM A123 total both sides). These products require hot-dip galvanized fasteners (fasteners which meet the specifications of ASTM A153).
Simpson Strong-Tie® nails and structural fasteners have been developed as the optimum fasteners for connector products. Special lengths afford economy of purchase and installation, and depth compatibility with framing members.
Nail Types and Sizes Specified for Simpson Strong-Tie® Connectors
Many Simpson Strong-Tie connectors have been designed and tested for use with specific types and sizes of nails. The specified quantity, type and size of nail must be installed in the correct holes on the connector to achieve published loads. Other factors such as nail material and finish are also important. Incorrect fastener selection or installation can compromise connector performance and could lead to failure.
In some cases it is desirable to install Simpson Strong-Tie face mount joist hangers and straight straps with nails that are a different type or size than what is called out in the load table. In these cases these reduction factors must be applied to the allowable loads listed for the connector. (see the attached load adj factor picture table)
10dx1 1/2" or 16dx2 1/2" nails may not be substituted for joist nails in double-shear hangers (i.e. LUS, MUS, HUS, HHUS, HGUS).
Do not substitute 10dx1 1/2" nails for face nails on slope and skew combinations or skewed only LSU and LSSU.
For straps installed over sheathing 1 1/2" nails should not be used.
The attached table pictured.... does not apply to specials (see Hanger Options), or steel thicker than 10 gauge. Face mount hangers joist and face nails (except as noted) and straight straps may be installed with alternate nails. Use this table to determine the load adjustment factor.
Where noted, use 0.80 for 10 ga, 11 ga, and 12 ga products when using SPF lumber.
Where noted, use 0.92 for 10 ga, 11 ga, and 12 ga products when using SPF lumber.
N16 fasteners may be ordered electro-galvanized; specify EG; for example N16EG. This finish is not acceptable for ZMAX® or HDG applications.
HDG = hot-dip galvanized; SS = stainless steel; Bright = no finish; GV = green vinyl.
Metric equivalents are listed (Diameter x Length).
The 8d common, 10d common, 12d common, 16d common, and 16d sinker nails are for reference only. Simpson does not sell these nails. All other nails are available through Simpson.
For pneumatic fastener info, request additional technical information.
Recommended minimum end distance to prevent splitting with a steel side member is 10 x the nail diameter per 2005 NDS Commentary Table 184.108.40.206.
Use HDG nails with ZMAX and HDG products.
16d sinker with GV finish is not acceptable for ZMAX or HDG applications.
HDG nails sold by Simpson meet the specifications of ASTM A153. Stainless steel nails are type 316 stainless.
The following pdf downloads may be helpful to your application