|SIMPSON STRONG-TIE Z-MAX HURRICANE TIES
The Hurricane Tie series features various configurations of wind and seismic ties for trusses and rafters.
ZMAX....Triple coated Zinc for Corrosion Resistance
H7Z and H11Z - ZMAX®.
Some models available in stainless steel or ZMAX®
H1Z USES: 6 - HDG 8D X 1-1/2 for fastening to rafters/truss
4 - HDG 8D X 1-1/2 for fastening to PLATES
SEE RECOMMEND FASTENERS ATTACHED BELOW
- H1 can be installed with flanges facing inwards
- H2.5, H2.5T, H3, H4, H5 and H6 ties are only shipped in equal quantities of rights and lefts.
- The HGA10KT: screws are provided.
- HS24 requires slant nailing only when bottom chord of truss or rafter has no slope.
- Hurricane Ties do not replace solid blocking.
The NEW H10S provides a high capacity connection from truss/rafter to stud. A flexible nailing pattern allows installation where the stud is offset from the rafter up to 1". Suitable for wood-to-wood and wood-to-CMU/concrete applications.
The H2.5T's truncated design was developed to accommodate trusses with 2x4 bottom chords. The easy to install, five nail pattern is stronger and gets better uplift loads than our popular H2.5 hurricane tie.
The H14 is the high uplift hurricane tie. It can be installed with rafter nailing flanges facing inwards or outwards.
The H2.5A is designed for easy installation, with higher uplift loads to meet new code requirements.
The H16-2 series has a presloped seat of 5:12 for double trusses.
The presloped 5/12 seat of the H16 provides for a tight fit and reduced deflection. The strap length provides for various truss height up to a maximum of 13 1/2" (H16 series). Minimum heel height for H16 series is 4".
The HGA10 attaches to gable trusses and provides good lateral wind resistance. The HS24 attaches the bottom chord of a truss or rafter at pitches from 0:12 to 4:12 to double 2x4 top plates. Double shear nailing allows for higher lateral resistance.
The following pdf download may be helpful with your application: